OL-103 Introduction to SCS900 for Sites, On-line

This introductory course teaches the basic information and skills needed to:

• Create a site and work order and select a design
• Demonstrate how to start and configure a base station and rover
• Demonstrate how to conduct a one point and full site calibrate and edit unacceptable results
• Measure a surface with and without a design: using standing and walking mode
• Stakeout a line, surface and level plane
• Run a surface grade and thickness check reports
• Demonstrate how to measure a stockpile with and without a design

Grade checkers and site engineers that are new users of Trimble SCS900 Site Controller Software v2.33

The estimated time to complete this entire course is 2 to 2.5 hours.  Trimble recommends that you do not complete the course all at once.  You can do a module or lesson now, and come back to do the others later.  When you exit the course, it will set a bookmark so you start your next session where you left off.

Ability to navigate and name files in a Window's environment.
One year experience with grade checking.

Trimble SCS900 Site Controller Software v2.33

• Internet Explorer v6.0 or higher is the only supported browser for this course; other browsers may support this content but it has not been tested.
• The optimum screen resolution for this course is 1280 x 1024.
• This course is launched in a separate window, All pop-up blockers must be disabled or turned off before accessing this course.
• This course requires a Flash player plug-in.  If you do not have a Flash plug-in installed on your computer, the system prompts you to download the latest Flash plug-in.  You can get the plug-in at Adobe's® website.